It hangs from a piece of wire that is threaded through holes drilled in the front and back sections.
Diy birdhouse with license plate roof.
May 18 2020 explore bill bramblett s board license plate birdhouses on pinterest.
34 diy bird houses 1.
Diy birdhouse with a pretty penny roof.
Most of this birdhouse is built with wood but a metal license plate makes up the roof.
Building a rustic style birdhouse from cedar pickets diy.
First mark the center of the license plate as shown below.
If you don t have an old license plate you can substitute the license plate roof with a piece of 12 x 6 galvanized metal.
Build a modern birdhouse.
The birdhouse will hang in a diamond position with a point at the bottom and the point of the bent license plate roof at the top.
Next position this bend line over the straight edge of a table or work bench and bend down.
The depth in 5.
Lay the front piece of wood on a flat surface in a diagonal position.
Attach the license plate to the birdhouse using only screws.
This cute little birdhouse is made from just four small scraps of wood and uses a folded license plate as the roof.
Center it over the roof support on the house.
This plan will get you a very simple and straightforward birdhouse that can be nailed to a tree or post.
Cut two pieces of 3 4 inch wood measuring 4 1 2 inches square with a power saw.
For the roof we recycled some old license plates and painted them the kids favorite colors yes even the camo wood.
Just like the other nest boxes one side opens by pivoting on two screws for access to the interior.
The license plate birdhouse is an easy to build bird house design that can be a home for wrens titmice finches sparrows chickadees bluebirds and other small cavity nesting birds.
These are the front and back of the birdhouse.
See more ideas about bird houses license plate bird house.
Drill holes for the pan head screws or roofing nails.
Diy nail less screw.
This will prevent the wood from splitting when you put in the hardware.
Simple bird house plan.
Find the center of your license plate and bend it to a 45 degree angle.
Keep bending until the angle on the license plate matches the roof angle on the birdhouse.